LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Steering Wheel & Steering Column) >> Repair Instructions >> Multifunction, Turn Signal Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Tilt the column to the CENTER position.
  4. Disconnect the connectors from the turn signal and multifunction switch assembly.
  5. Remove the turn signal and multifunction switch assembly.
    Fig 1: Removing/Installing Turn Signal Switch Assembly
    GM761439Courtesy of GENERAL MOTORS CORP.
  6. Remove 2 pan head tapping screws from the turn signal and multifunction switch assembly.
scientia non olet · About LEMON Manuals