Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the turn signal and multifunction switch assembly.
- Secure by using 2 pan head tapping screws.
Tighten:
- Tighten the screw on the top of the column to 3 N.m (27 lb in).
- Tighten the screw on the side to 7 N.m (62 lb in).
- Connect the connectors to the turn signal and multifunction switch assembly.
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
IMPORTANT:
The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.