LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Steering Wheel & Steering Column) >> Repair Instructions >> Multifunction Turn Signal Switch Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the steering wheel from the column. Refer to Steering Wheel Replacement .
  3. Remove the ignition lock cylinder case assembly. Refer to Ignition Lock Cylinder Case Replacement .
  4. Remove the turn signal and multifunction switch assembly. Refer to Multifunction, Turn Signal Switch Replacement .
  5. Slide the turn signal switch housing off of the steering column shaft assembly.
    Fig 1: View Of Turn Signal Switch Housing & Steering Column Shaft Assembly
    GM664269Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals