Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Slide the turn signal switch housing onto the steering column shaft assembly.
- Install the turn signal and multifunction switch assembly. Refer to Multifunction, Turn Signal Switch Replacement .
- Install the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
- Install the steering wheel onto the column. Refer to Steering Wheel Replacement .
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
IMPORTANT:
The turn signal switch housing must be pressed firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly screws to line up.