LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
    2. CAUTION: Refer to SIR Caution in Cautions and Notices.
  2. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  3. Lower the hush and knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gauges, and Console.
  4. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  5. With the key installed, turn the key to the RUN position.
    6. Fig 1: Releasing/Installing Lock Cylinder Using Allen Wrench
    GM1413814Courtesy of GENERAL MOTORS CORP.
  6. Install an Allen wrench into the hole on top of the lock cylinder housing.

    Push down on the Allen wrench to release the tab on the lock cylinder inside the lock cylinder housing.

    7. Fig 2: View Of Lock Cylinder At Lock Cylinder Housing
    GM1413837Courtesy of GENERAL MOTORS CORP.
  7. Slide the lock cylinder out of the lock cylinder housing.
scientia non olet · About LEMON Manuals