Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: View Of Lock Cylinder Housing TORX Screws

Courtesy of GENERAL MOTORS CORP.

Install 3 TORX® screws into the lock cylinder housing.
Tighten: Tighten the TORX® screws to 7 N.m (62 lb in).
Install the turn signal cancel cam. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .
Install the park lock cable into the lock cylinder housing.
Install the ignition switch. Refer to Ignition Switch Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.