LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Steering Wheel & Steering Column) >> Diagnostic Information and Procedures >> Steering Column Tilt Function Inoperative

Steering Column Tilt Function Inoperative

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Steering Column Tilt Function Inoperative

Step Action Yes No
1 Did you review the Steering Wheel and Column Description and Operation and perform the necessary inspections? Go to Step 2  Go to Steering Wheel and Column Description and Operation 
2 Verify that the steering column tilt function is inoperative.
Does the steering column tilt function operate normally?
System OK Go to Step 3 
3 Verify that the shoe is not seized on the pivot pin.
Is the shoe seized on the pivot pin?
Go to Step 9  Go to Step 4 
4 Inspect the shoe grooves for dirt, burrs, or rust.
Are the shoe grooves free of dirt, burrs, and rust?
Go to Step 9  Go to Step 5 
5 Inspect for a weak or broken shoe lock spring.
Is the shoe lock spring weak or broken?
Go to Step 9  Go to Step 6 
6 Inspect the pivot pins for binding.
Are the pivot pins binding?
Go to Step 10  Go to Step 7 
7 Inspect for a weak or broken wheel tilt spring.
Is the wheel tilt spring weak or broken?
Go to Step 11  Go to Step 8 
8 Inspect the steering column wiring harness for tightness.
Is the steering column wiring harness too tight?
Go to Step 12  Go to Step 3 
9 Replace the tilt head. Refer to Steering Column Tilt Head Housing Replacement  .
Is the repair complete?
Go to Step 13  -
10 Replace the pivot pins. Refer to Steering Column Tilt Head Housing Replacement  .
Is the repair complete?
Go to Step 13  -
11 Replace the tilt spring. Refer to Tilt Spring Replacement  .
Is the repair complete?
Go to Step 13  -
12 Reroute the steering column wiring harness to the correct location.
Is the steering column wiring harness routed properly?
Go to Step 13  -
13 Operate the steering column tilt function in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3