Lock System Sticks in Start
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Lock System Sticks in Start
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Steering Wheel and Column Description and Operation? | Go to Step 2 | Go to Steering Wheel and Column Description and Operation |
| 2 | Verify that the lock system sticks in the START position. Does the lock system operate normally? |
System OK | Go to Step 3 |
| 3 | Inspect the ignition lock cylinder case assembly for damage. Is the ignition lock cylinder case assembly damaged? |
Go to Step 6 | Go to Step 4 |
| 4 | Inspect the lock cylinder for damage. Is the lock cylinder damaged? |
Go to Step 7 | Go to Step 5 |
| 5 | Inspect the ignition switch for damage. Is the ignition switch damaged? |
Go to Step 8 | Go to Step 3 |
| 6 | Replace the ignition lock cylinder case assembly. Refer to Ignition Switch Replacement . Did you complete the repair? |
Go to Step 9 | - |
| 7 | Replace the lock cylinder. Refer to Ignition Lock Cylinder Replacement . Did you complete the repair? |
Go to Step 9 | - |
| 8 | Replace the ignition switch. Refer to Ignition Switch Replacement . Did you complete the repair? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |