LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1398 (Wiring Systems (Diagnostic Information And Procedures)) >> Diagnostic Information and Procedures >> Testing for Short to Ground >> Fuse Powering Several Loads

Fuse Powering Several Loads

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Review the system schematic and locate the fuse that is open.
  2. Open the first connector or switch leading from the fuse to each load.
  3. Connect a DMM across the fuse terminals (be sure that the fuse is powered).
    • When the DMM displays voltage the short is in the wiring leading to the first connector or switch.
    • If the DMM does not display voltage refer to the next step.
  4. Close each connector or switch until the DMM displays voltage in order to find which circuit is shorted.
scientia non olet · About LEMON Manuals