LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1398 (Wiring Systems (Diagnostic Information And Procedures)) >> Diagnostic Information and Procedures >> Testing for Continuity >> With a Test Lamp

With a Test Lamp

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Only use the test lamp procedure on low impedance power and ground circuits.
  1. Remove the power feed (i.e. fuse, control module) from the suspect circuit.
  2. Disconnect the load.
  3. Connect 1 lead of the test lamp to 1 end of the circuit to be tested.
  4. Connect the other lead of the test lamp to battery positive voltage.
  5. Connect the other end of the circuit to ground.
  6. If the test lamp illuminates (full intensity), then the circuit has good continuity.
scientia non olet · About LEMON Manuals