LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1398 (Wiring Systems (Diagnostic Information And Procedures)) >> Diagnostic Information and Procedures >> Measuring Frequency

Measuring Frequency

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Test Probe Notice in Cautions and Notices.

The following procedure determines the frequency of a signal.

IMPORTANT: Connecting the DMM to the circuit before pressing the Hz button will allow the DMM to autorange to an appropriate range.
  1. Apply power to the circuit.
  2. Set the rotary dial of the DMM to the V (AC) position.
  3. Connect the positive lead of the DMM to the circuit to be tested.
  4. Connect the negative lead of the DMM to a good ground.
  5. Press the Hz button on the DMM.
  6. The DMM will display the frequency measured.
scientia non olet · About LEMON Manuals