LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1398 (Wiring Systems (Diagnostic Information And Procedures)) >> Connector Repairs >> Weather Pack Connectors

Weather Pack Connectors

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The following is the proper procedure for the repair of Weather Pack® Connectors.

    Fig 1: View Of Connector Halves
    GM8802Courtesy of GENERAL MOTORS CORP.
  1. Separate the connector halves (1).
  2. Open the secondary lock. A secondary lock aids in terminal retention and is usually molded to the connector (1).
  3. Grasp the wire and push the terminal to the forward most position. Hold the wire in this position.
    4. Fig 2: Removing Cable & Terminal From Connector
    GM8803Courtesy of GENERAL MOTORS CORP.
  4. Insert the Weather Pack® terminal removal tool into the front (mating end) of the connector cavity until it rests on the cavity shoulder (1).
  5. Gently pull on the wire to remove the terminal through the back of the connector (2).
    IMPORTANT: Never use force to remove a terminal from a connector.
  6. Inspect the terminal and connector for damage. Repair as necessary. Refer to Repairing Connector Terminals .
  7. Reform the lock tang (2) and reset terminal in connector body.
  8. Close secondary locks and join connector halves.
  9. Verify that circuit is complete and working satisfactorily.
  10. Perform system check.
scientia non olet · About LEMON Manuals