LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1398 (Wiring Systems (Diagnostic Information And Procedures)) >> Connector Repairs >> Pull to Seat Connectors >> Terminal Repair

Terminal Repair

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the wire needed to be cut in order to remove the terminal, gently push a small length of the same size wire through the back of the connector cavity until there is enough wire exposed in order to crimp on a new terminal. If the wire was not cut, cut the existing wire as close to the old terminal as possible.
  2. Strip 5 mm (3/16 in) of insulation from the wire.
  3. Crimp a new terminal to the wire.
  4. Solder the crimp with rosin core solder.
scientia non olet · About LEMON Manuals