LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Replacement - Front Bucket >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer toSIR Caution in Cautions and Notices.
  1. Disable SIR. Refer to SIR Disabling and Enabling Zone 7 and to SIR Disabling and Enabling Zone 9 in SIR.
    2. IMPORTANT: Before removing the seat, ensure that the following conditions are met:
    • For power seats, verify that the seat bottom is fully down.
    • The seat back is in the full upright position.
    • The upper and lower seat rails are flush at rear.
  2. Remove the seat mounting fastener covers.
    3. Fig 1: Removing/Installing Seat - Front Bucket
    GM722607Courtesy of GENERAL MOTORS CORP.
  3. Remove the 3 front seat mounting nuts.
  4. Remove the front seat mounting bolt.
  5. Disconnect the electrical harness. Unclip the harness from the seat bracket.
  6. Remove the seat from the vehicle.
  7. Place the seat on a clean, prepared surface.
scientia non olet · About LEMON Manuals