LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Latch Rod Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat latch rod (1) to the inner and outer riser assemblies.
    2. Fig 1: Identifying Seat Latch Rod Retainer Nut
    GM824155Courtesy of GENERAL MOTORS CORP.
  2. Install a retainer nut (2) on each end of the seat latch rod (1).
    3. Fig 2: Removing/Installing Seat Riser Latch Assembly At Seat Latch Rod
    GM824156Courtesy of GENERAL MOTORS CORP.
  3. Install the seat riser latch assembly (1) to the seat latch rod (2).
    4. Fig 3: Underside Of Seat View
    GM824146Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the rear seat cushion assembly (1) to the seat latch rod (3) with two bolts (2).

    Tighten:  Tighten the rear seat cushion bolts to 11 N.m (97 lb in).

  5. Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 2 .
scientia non olet · About LEMON Manuals