Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Seat Cushion Trim Panel To Seat Frame Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws securing the seat cushion trim panel to the seat cushion assembly.
Tighten: Tighten the rear seat cushion trim panel screws to 2 N.m (18 lb in).

Fig 2: Identifying Seat Cover J Strips

Courtesy of GENERAL MOTORS CORP.

Install the seat cover J-strips (1) to the seat cushion trim panel (2).

Fig 3: Locating Seat Cushion Trim Panel Support Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 2 bolts (2) securing the support (1) to the seat cushion trim panel.
Tighten: Tighten the rear seat support bolts to 35 N.m (26 lb ft).

Fig 4: Identifying Rear Seat Bracket Trim Covers & Rear Seat Bracket Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

Install the rear seat bracket with the 4 mounting nuts (2).
Tighten: Tighten the rear seat bracket mounting nuts to 25 N.m (18 lb ft).
Install the rear seat bracket trim covers (1).
Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .