LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Cushion Panel Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Pull Handle
    GM824148Courtesy of GENERAL MOTORS CORP.
  1. Install the seat cushion panel on the pad and cover.
  2. Install the J-strips (2) securing the seat cushion cover to the seat cushion panel.
  3. Install the pull handle (1). Refer to Pull Handle Assembly Replacement - Rear No. 2 .
    4. Fig 2: Underside Of Seat View
    GM824146Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the rear seat cushion assembly (1) to the seat latch rod (3) with two rear seat cushion bolts (2).

    Tighten:  Tighten the rear seat cushion bolts to 11 N.m (97 lb in).

scientia non olet · About LEMON Manuals