LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trim panel from the power seat by performing the following:
    1. Remove the 3 seat switch bezel mounting screws. Refer to Seat Switch Bezel Replacement .
      2. Fig 1: Removing/Installing Seat Cushion Outer Trim Panel (Switch Side)
      GM752954Courtesy of GENERAL MOTORS CORP.
    2. Remove the 3 trim panel retaining screws.
  2. Remove the trim panel from the manual seat by performing the following steps:
    1. Remove the lumbar support knob. Refer to Lumbar Support Knob Replacement .
    2. Remove the seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front .
      3. Fig 2: Removing/Installing Seat Cushion Outer Trim Panel (Recliner Handle Side)
      GM755843Courtesy of GENERAL MOTORS CORP.
    3. Remove the screws from the trim panel.
  3. Remove the trim panel from the seat assembly.
scientia non olet · About LEMON Manuals