LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the trim panel to the power seat by performing the following steps:
      Fig 1: Removing/Installing Seat Cushion Outer Trim Panel (Switch Side)
      GM752954Courtesy of GENERAL MOTORS CORP.
    1. Align the trim panel to the seat assembly.
      2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    2. Install the screws retaining the trim panel to the seat assembly.

      Tighten:  Tighten the trim panel screws to 3 N.m (26 lb in).

    3. Install the 3 seat switch bezel mounting screws.

      Tighten:  Tighten the seat switch bezel mounting screws to 3 N.m (26 lb ft).

  2. Install the trim panel to the manual seat by performing the following steps:
      Fig 2: Removing/Installing Seat Cushion Outer Trim Panel (Recliner Handle Side)
      GM755843Courtesy of GENERAL MOTORS CORP.
    1. Install the screws in the trim panel.
    2. Install the lumbar support knob. Refer to Lumbar Support Knob Replacement .
    3. Install the seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front .
scientia non olet · About LEMON Manuals