Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Seat Cushion Latch Release Assembly - Rear No. 1 (TrailBlazer, Envoy, Bravada)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 3 bolts securing the rear seat cushion latch to the seat pan.
Tighten: Tighten the rear seat cushion latch release bolts to 10 N.m (88 lb in).

Fig 2: Removing/Installing Strap From Rear Seat Cushion Latch Release Assembly - Rear No. 1 (TrailBlazer, Envoy, Bravada)

Courtesy of GENERAL MOTORS CORP.

Install the small loop (1) onto the rear seat cushion latch (2).
Install the strap through the opening in the seat pan.
Install the rear-seat cushion cover and the pad. Refer to Seat Cushion Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) or Seat Cushion Cover and Pad Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
Install the rear seat cushion assembly to the vehicle. Refer to Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) .