LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Cushion Frame Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 seat switch bezel mounting screws. Refer to Seat Switch Bezel Replacement .
    2. Fig 1: View Of Underside Of Seat Adjuster Frame & Mounting Nuts
    GM752864Courtesy of GENERAL MOTORS CORP.
  2. Remove the 4 nuts that secure the seat pan to the power seat adjuster frame.
  3. Remove the clip from the front outboard seat pan stud, if equipped. Discard the clip.
    4. Fig 2: Identifying Connectors & Harness
    GM752865Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the black electrical connector (6) from the seat back harness.
  5. Disconnect the black electrical connector (3) from the seat belt buckle.
  6. Disconnect the gray lumbar electrical connector (5), if equipped.
  7. Remove the SIR harness (2) from the harness clips (1, 4), and remove the SIR harness from the seat.
  8. Remove the seat harness from the seat pan.
  9. Remove the seat memory module, if equipped. Refer to Memory Seat Control Module Replacement .
  10. Remove the seat cushion assembly.
  11. Remove the seat cushion cover and pad from the seat frame. Refer to Seat Cushion Cover and Pad Replacement - Front .
  12. Remove the wiring harness and connector clips, if you are replacing the frame.
scientia non olet · About LEMON Manuals