LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear No. 2 >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Underside Of Seat View
    GM824146Courtesy of GENERAL MOTORS CORP.
  1. Remove the two bolts (2) securing the rear seat cushion assembly (1) to the seat latch rod (3).
  2. Remove the rear seat cushion assembly.
    3. Fig 2: Removing/Installing Pull Handle
    GM824148Courtesy of GENERAL MOTORS CORP.
  3. Remove the pull handle assembly (1). Refer to Pull Handle Assembly Replacement - Rear No. 2 .
  4. Remove the J-strips (2) securing the rear seat cushion cover to the seat cushion panel.
  5. Remove the seat cushion panel from the pad and cover.
    6. Fig 3: Locating Hog Rings
    GM824149Courtesy of GENERAL MOTORS CORP.
  6. Remove the hog rings (1) from the seat cover.
    7. Fig 4: Identifying Hook & Loop Fasteners
    GM824170Courtesy of GENERAL MOTORS CORP.
  7. Carefully separate the hook and loop fastener strips (2) holding the cover to the pad.
  8. Remove the hog rings (1).
scientia non olet · About LEMON Manuals