LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cover to the cushion.
  2. Install the reinforcement bar to the hog-rings.
  3. Attach the retaining strips that retain the cover to the cushion.
  4. In order to install the seat cushion to the seat pan, perform the following:
  5. Install the seat pan to the cushion and cover assembly.
  6. Compress the foam and install the seat cover and cushion to the seat pan.
    7. Fig 1: Removing/Installing Seat Cushion Cover - Rear No. 1 (TrailBlazer, Envoy, Bravada)
    GM753722Courtesy of GENERAL MOTORS CORP.
  7. Connect the J-strips that retain the cover to the seat pan.
    8. Fig 2: Locating Push Pins At Underside Of Seat Bottom
    GM753710Courtesy of GENERAL MOTORS CORP.
  8. Install the push pins (1) on the underside of the seat bottom.
    9. Fig 3: Locating Seat Latch Bezel
    GM753715Courtesy of GENERAL MOTORS CORP.
  9. Install the latch bezels.
  10. Install the seat cushion bracket. Refer to Seat Cushion Bracket Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Cushion Bracket Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
  11. Install the seat cushion in the vehicle. Refer to Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) .
scientia non olet · About LEMON Manuals