LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cover to the cushion.
  2. Install the reinforcement bar to the hog-rings.
  3. Attach the retaining strips that retain the cover to the cushion.
  4. In order to install the seat cushion to the seat pan, perform the following:
  5. Install the seat pan to the cushion and cover assembly.
  6. Compress the foam and install the seat cover and cushion to the seat pan.
    7. Fig 1: Identifying Seat Cover J Strips
    GM828226Courtesy of GENERAL MOTORS CORP.
  7. Connect the J-strips that retain the cover to the seat pan.
scientia non olet · About LEMON Manuals