LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 seat switch bezel screws. Refer to Seat Switch Bezel Replacement .
    2. Fig 1: View Of Underside Of Seat Adjuster Frame & Mounting Nuts
    GM752864Courtesy of GENERAL MOTORS CORP.
  2. Remove the 4 nuts that retain the seat pan to the seat adjuster assembly.
  3. Remove the clip from the front outboard seat pan stud, if equipped. Discard the clip.
    4. Fig 2: Identifying Seat Cushion J Strips
    GM752956Courtesy of GENERAL MOTORS CORP.
  4. Release the J strips (1,3) on each side of the seat cushion.
  5. Release the front/rear J strips (2,4).
    6. Fig 3: Identifying Connectors & Harness
    GM752865Courtesy of GENERAL MOTORS CORP.
  6. Remove the SIR electrical harness (2) from the seat pan.
  7. Remove the seat electrical harness from the seat pan.
  8. Remove the wire harness fasteners from the seat pan.
  9. Disconnect the seat cushion heater electrical connector, if equipped.
    10. IMPORTANT: When separating the seat cover hook and loop retaining strips, do not pull the adhesive-backed strip from the seat pad.
  10. Separate the hook and loop retaining strips.
    11. Fig 4: Identifying Hog Rings At Bottom Rear Side Of Seat Cover
    GM752959Courtesy of GENERAL MOTORS CORP.
  11. Remove the hog rings (1) from the bottom rear side of the cover.
  12. Remove the 11 hog rings from the top side of the cover.
  13. Remove the seat cushion trim cover and pad from the seat frame.
    14. Fig 5: Locating Seat Module Retaining Screw
    GM752957Courtesy of GENERAL MOTORS CORP.
  14. Remove the seat module retaining screw, if equipped.
  15. Remove the seat module, if equipped.
  16. Remove the seat cover from the seat cushion.
  17. Remove the seat cushion from the seat pan.
scientia non olet · About LEMON Manuals