LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Cushion Bracket Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Seat Cushion Bracket Assembly To Seat Cushion (TrailBlazer, Envoy, Bravada)
    GM753711Courtesy of GENERAL MOTORS CORP.
  1. Position the bracket assembly on the seat cushion.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: Locating Seat Cushion Bracket Assembly To Seat Cushion Bolts (TrailBlazer, Envoy, Bravada)
    GM753713Courtesy of GENERAL MOTORS CORP.
  2. Install the 2 bolts securing the bracket assembly to the seat cushion.

    Tighten:  Tighten the rear seat cushion bracket bolts to 25 N.m (18 lb ft).

  3. Install the rear seat cushion assembly in the vehicle. Refer to Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) .
scientia non olet · About LEMON Manuals