LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Back Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Seat Back - Rear No. 1 (TrailBlazer, Envoy, Bravada)
    GM722617Courtesy of GENERAL MOTORS CORP.
  1. Tumble the left seat back in order to gain access to the left 2 rear seat back mounting nuts.
  2. Remove the left 3 rear seat back mounting nuts.
  3. Return the left seat back to the upright position.
  4. Remove the left 2 front seat back mounting nuts.
  5. Remove the left seat back from the vehicle.
  6. If removing the right seat back, perform the following:
    1. Remove the left seat back first.
    2. Tumble the right seat back in order to gain access to the right rear seat back mounting nut.
    3. Remove the right rear seat back mounting nut.
    4. Return the right seat back to the upright position.
    5. Remove the right front seat back mounting nut.
    6. Remove the navigation control processor bracket from the floor panel, if equipped. Refer to Navigation Control Processor Bracket Replacement (TrailBlazer, Envoy, Bravada) or Navigation Control Processor Bracket Replacement (TrailBlazer EXT, Envoy XL) in Cellular Communication.
    7. Remove the right seat back from the vehicle.
scientia non olet · About LEMON Manuals