Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Seat Back Release Latch Cable Clips

Courtesy of GENERAL MOTORS CORP.

Install the clips securing the seat back release latch cable to the seat back frame.
Install the cable end into the cam (1).
Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) or Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the seat back release latch handle to the seat back with 2 screws.
Tighten: Tighten the seat back release latch handle screws to 2 N.m (18 lb in).