LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Back Hinge Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Partially remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
    2. Fig 1: Identifying Cables At Left-Hand Hinge Bracket
    GM753531Courtesy of GENERAL MOTORS CORP.
  2. Remove the latch release cables (1) from the latch release mechanism, located at the bottom of the seat back frame.
  3. Remove the head restraint release cable (2) from the left hand hinge bracket.
  4. Remove the bolts (2) that retain the latch bracket to the hinge bracket.
    Fig 2: Identifying Hinge Bracket Bolts
    GM753533Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolts (1) that retain the hinge bracket to the seat back frame.
  6. Remove the hinge bracket from the seat back frame.
scientia non olet · About LEMON Manuals