Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the inboard/outboard rear seat back hinge cover halves around the seat back hinges.

Fig 1: Identifying Seat Belt Side Buckle & Retaining Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the inboard/outboard rear seat back hinge cover screws.
Tighten: Tighten the rear seat back hinge cover screws to 2 N.m (18 lb in).