LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 2 >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the head restraint assembly. Refer to Head Restraint Replacement - Rear Seat .
    2. Fig 1: Extension Panel Hinge Trim
    GM824160Courtesy of GENERAL MOTORS CORP.
  2. Remove the extension panel hinge trim (2).
  3. Remove the screws (3) securing the extension panel (1) to the seat back.
    4. Fig 2: Accessing Seat Back Screws
    GM824159Courtesy of GENERAL MOTORS CORP.
  4. Remove the J-strip (1) from the seat adjuster cross bar (2).
    5. Fig 3: Unhooking the J-strip
    GM824164Courtesy of GENERAL MOTORS CORP.
  5. Unhook the J-strip (1) from the bottom of the seat back cover.
  6. Remove the hog rings (2) from the seat back cover flaps.
    7. Fig 4: Identifying Hook & Loop Fasteners
    GM824170Courtesy of GENERAL MOTORS CORP.
  7. Pull the seat back cover up by releasing the hook and loop fastener strips (2).
  8. Remove the hog rings (1) securing the cover to the pad.
    9. Fig 5: Accessing Head Rest Restraint Guides
    GM824173Courtesy of GENERAL MOTORS CORP.
  9. Gently pull the pad away from the seat back frame. It may be glued in places from its original assembly.
  10. Remove the head rest restraint guides by squeezing the tabs on the bottom of the guide together and pulling the guide upward out of the seat.
  11. Remove the cover and pad from the seat back frame.
scientia non olet · About LEMON Manuals