LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the pad on the seat back frame.
  2. Fit the seat back cover over the top of the seat back frame and pad.
    3. Fig 1: View Of Head Restraint Guide Locking Tab
    GM752739Courtesy of GENERAL MOTORS CORP.
  3. Install the head restraint guides by pushing them through the cover into the frame until the locking tabs snap into place. The guide with the locking tab (1) installs on the right hand side of the seat.
    4. Fig 2: Identifying Hook & Loop Fasteners
    GM824170Courtesy of GENERAL MOTORS CORP.
  4. Install the hog rings (1) to the cover and pad.
  5. Pull the seat back cover down over the pad pressing the hook and loop fastener strips (2) together.
    6. Fig 3: Unhooking the J-strip
    GM824164Courtesy of GENERAL MOTORS CORP.
  6. Install the seat back cover flap to the pad with the hog rings (2).
  7. Install the J-strips (1) across the bottom of the seat back cover.
    8. Fig 4: Accessing Seat Back Screws
    GM824159Courtesy of GENERAL MOTORS CORP.
  8. Install the J-strip (1) to the seat adjuster cross bar (2).
    9. Fig 5: Extension Panel Hinge Trim
    GM824160Courtesy of GENERAL MOTORS CORP.
  9. Install the screws (3) securing the extension panel (1) to the seat back.
  10. Install the extension panel hinge trim (2).
  11. Install the head restraint assembly. Refer to Head Restraint Replacement - Rear Seat .
scientia non olet · About LEMON Manuals