LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat back from the vehicle. Refer to Seat Back Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
  2. Remove the seat belt buckle bracket, on the right side only.
    3. Fig 1: Locating Seat Belt Anchor Bolt - Rear No. 1 Seat (TrailBlazer, Envoy, Bravada)
    GM753723Courtesy of GENERAL MOTORS CORP.
  3. Remove the seat belt anchor bolt from the bracket.
    4. Fig 2: Identifying Seat Belt Bezel Plastic Retainer Buttons
    GM753729Courtesy of GENERAL MOTORS CORP.
  4. Release the seat belt bezel from the seat back by pressing in the buttons (1) on the plastic retainers.
  5. Remove the seat belt bezel by sliding it off the seat belt.
  6. Remove the head restraints. Refer to Head Restraint Replacement - Rear Seat .
    7. Fig 3: Removing Release Latch Knob
    GM753555Courtesy of GENERAL MOTORS CORP.
  7. Remove the release latch knob.
    8. Fig 4: Removing/Installing Seat Back Latch Release Bezel
    GM753553Courtesy of GENERAL MOTORS CORP.
  8. Remove the screw that retains the seat back latch release bezel to the seat back.
    9. Fig 5: Locating J-Strips At Bottom Of Seat Back Frame
    GM753560Courtesy of GENERAL MOTORS CORP.
  9. Release the J-strips on the bottom of the seat back frame.
  10. Release the hook and loop retaining strips at the bottom of the seat back.
  11. Remove 3 push-pins from the bottom of the seat back.
    12. Fig 6: Locating Hook & Loop Retaining Strips
    GM753548Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the hook and loop retaining strips remain attached to the seat back pad.
  12. Release the cover from the hook and loop retaining strips on the front of the seat back pad.
    13. Fig 7: Locating Seat Back Push Pins
    GM753549Courtesy of GENERAL MOTORS CORP.
  13. Remove the 6 push-pins from the seat back.
  14. Remove the cover and pad from the seat back.
    15. Fig 8: Removing/Installing Cover & Pad From Seat Back
    GM753704Courtesy of GENERAL MOTORS CORP.
  15. Release the 3 hog-rings from the reinforcement bar.
  16. Remove the seat cover from the pad.
scientia non olet · About LEMON Manuals