LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat back pad to the seat back frame.
    2. Fig 1: Locating Seat Back Push Pins
    GM753549Courtesy of GENERAL MOTORS CORP.
  2. Install the 6 push-pins that retain the seat back pad to the seat back frame.
  3. Partially install the seat cover.
    4. Fig 2: Removing/Installing Cover & Pad From Seat Back
    GM753704Courtesy of GENERAL MOTORS CORP.
  4. Install the 3 hog-rings to the reinforcement bar.
  5. Install the seat cover the remainder of the way.
    6. Fig 3: Locating Hook & Loop Retaining Strips
    GM753548Courtesy of GENERAL MOTORS CORP.
  6. Engage the seat cover to the hook and loop retaining strips on the seat back pad.
    7. Fig 4: Removing/Installing Seat Back Latch Release Bezel
    GM753553Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the screw that retains the rear seat back release latch bezel to the rear seat back.

    Tighten:  Tighten the rear seat back release latch bezel screw to 3 N.m (26 lb in).

    8. Fig 5: Locating J-Strips At Bottom Of Seat Back Frame
    GM753560Courtesy of GENERAL MOTORS CORP.
  8. Install the 3 push-pins at the bottom of the rear seat back.
  9. Engage the hook and loop retaining strips at the bottom of the rear seat back.
  10. Starting at either corner, engage the J-strips at the bottom of the rear seat back.
  11. Install the head restraints. Refer to Head Restraint Replacement - Rear Seat .
    12. Fig 6: Installing Seat Belt Bezel To Rear Seat Back
    GM753728Courtesy of GENERAL MOTORS CORP.
  12. Install the seat belt bezel to the rear seat back with the plastic retainers (2).
    13. Fig 7: Locating Seat Belt Anchor Bolt - Rear No. 1 Seat (TrailBlazer, Envoy, Bravada)
    GM753723Courtesy of GENERAL MOTORS CORP.
  13. Install the rear seat belt anchor bolt into the seat belt buckle bracket.

    Tighten:  Tighten the rear seat belt anchor bolt to 55 N.m (41 lb ft).

  14. Install the seat belt buckle bracket, on the right side only.
  15. Install the seat back into the vehicle. Refer to Seat Back Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
scientia non olet · About LEMON Manuals