LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the head restraint. Refer to Head Restraint Replacement - Rear Seat .
    2. Fig 1: Identifying Seat Belt Bezel Plastic Retainer Buttons
    GM753729Courtesy of GENERAL MOTORS CORP.
  2. Press in the buttons (1) on the plastic retainers.
  3. Remove the seat belt bezel from the top of the seat back by removing the plastic retainers and sliding the bezel off of the seat belt.
    4. Fig 2: Identifying Seat Belt Side Buckle & Retaining Nut
    GM828140Courtesy of GENERAL MOTORS CORP.
  4. Remove the 3 screws securing the inboard rear seat back hinge cover.
    5. Fig 3: View Of Rear Center Seat Belt Anchor Nut
    GM828141Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear seat belt anchor nut (2).
    6. Fig 4: Identifying J-Strips At Bottom Of Seat Back Cover
    GM893517Courtesy of GENERAL MOTORS CORP.
  6. Unhook the J-strips (3) from the bottom of the seat back cover (1).
  7. Remove the 2 push pins (2) from each side of the seat back.
  8. Pull the seat cover forward through the opening between the seat cushion and the seat back.
    9. Fig 5: Removing/Installing Seat Back Cover & Pad
    GM828143Courtesy of GENERAL MOTORS CORP.
  9. Release the hook and loop fasteners (2, 3) securing the cover to the pad.
  10. Remove the 3 hog rings (1) securing the cover to the pad.
    11. Fig 6: Locating Head Restraint Guide Retaining Tab
    GM828219Courtesy of GENERAL MOTORS CORP.
  11. Remove the head restraint guides by squeezing the retaining tabs (1) located at the bottom of the guides together.
  12. Remove the seat back cover and pad. The pad may be glued to the frame in places from the initial set assembly process.
scientia non olet · About LEMON Manuals