LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat back cover and pad on the seat back frame.
    2. Fig 1: View Of Head Restraint Guide Locking Tab
    GM752739Courtesy of GENERAL MOTORS CORP.
  2. Install the head restraint guides by pushing them through the cover into the frame until the locking tabs snap into place. The guide with the locking tab (1) installs on the right hand side of the seat.
    3. Fig 2: Removing/Installing Seat Back Cover & Pad
    GM828143Courtesy of GENERAL MOTORS CORP.
  3. Install the 3 hog rings (1) securing the cover to the pad.
  4. Pull the cover down over the pad ensuring that the hook and loop fasteners (2, 3) are pressed together.
  5. Pull the seat cover back through the opening between the seat cushion and the seat back.
    6. Fig 3: Identifying J-Strips At Bottom Of Seat Back Cover
    GM893517Courtesy of GENERAL MOTORS CORP.
  6. Install the cover side flaps to the frame with the 2 push pins (2) from each side of the seat back.
  7. Install the J-strips (3) on the bottom of the seat back cover (1).
    8. Fig 4: View Of Rear Center Seat Belt Anchor Nut
    GM828141Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Install the rear seat belt (1) to the seat with the rear seat belt anchor nut (2).

    Tighten:  Tighten the rear seat belt anchor nut to 55 N.m (41 lb ft).

    9. Fig 5: Identifying Seat Belt Side Buckle & Retaining Nut
    GM828140Courtesy of GENERAL MOTORS CORP.
  9. Install the inboard rear seat back hinge cover with 3 screws.

    Tighten:  Tighten the rear seat back hinge cover screws to 2 N.m (18 lb in).

    10. Fig 6: Installing Seat Belt Bezel To Rear Seat Back
    GM753728Courtesy of GENERAL MOTORS CORP.
  10. Install the seat belt bezel to the rear seat back with the plastic retainers (2).
  11. Install the head restraint assembly. Refer to Head Restraint Replacement - Rear Seat .
scientia non olet · About LEMON Manuals