LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust lumbar to a relaxed position.
  2. Remove the front seat assembly from the vehicle. Refer to Seat Replacement - Front Bucket .
  3. Remove the seat pad trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  4. Remove the head restraint. Refer to Head Restraint Replacement - Front Seat .
  5. Remove the screw that retains the seat belt bezel to the top of the seat back.
    Fig 1: Removing/Installing Seat Belt Bezel Retaining Screw
    GM752860Courtesy of GENERAL MOTORS CORP.
    6. Fig 2: Identifying J Strips
    GM752846Courtesy of GENERAL MOTORS CORP.
  6. Release the J-strips (1,4) across the bottom of the seat back cover.
  7. Remove the push pins (3) securing the seat cover (2) to the seat frame.
  8. Release the J-strips (1,4) across the bottom of the seat back cover.
    9. Fig 3: Identifying Seat Back Cover-To-Side Airbag Inflator Module Cover Plastic Strip Retainers
    GM752854Courtesy of GENERAL MOTORS CORP.
  9. Using a flat-bladed tool, carefully disengage the plastic strips that retain the seat back cover to the side airbag inflator module cover.
  10. Carefully remove the seat back cover from behind the trim edge of the side airbag inflator module.
    11. Fig 4: Removing/Installing Seat Cover
    GM752842Courtesy of GENERAL MOTORS CORP.
  11. Compress the seat back pad in order to relieve the pressure against the seat cover.
  12. Using a side to side motion, carefully lift off the seat back cover, partially separating the seat back cover from the foam pad.
    13. IMPORTANT: When separating the seat cover hook and loop retaining strips, do not pull the adhesive-backed strip from the pad.
  13. Release the lower Velcro retaining strips located inside the seat cover.
  14. Remove the 3 hog rings that retain the seat back pad to the reinforcement bar located at the top of the seat back.
    15. Fig 5: Identifying Head Restraint Guides
    GM752738Courtesy of GENERAL MOTORS CORP.
  15. Spread the pad apart and push the cover and pad up over the seat back in order to expose the head restraint guides.
  16. Remove the head restraint guides by squeezing the locking tabs together and pulling the restraint guides upward and out of the seat frame.
  17. Remove the seat back cover the remainder of the way from the seat back.
  18. Disconnect the electrical connector for the seat back heating element, located near the seat belt retractor, if equipped.
  19. Carefully remove the seat back pad from the seat back frame.
scientia non olet · About LEMON Manuals