LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Seat Adjuster Mechanism Replacement - Manual >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Seat Pan To Power Seat Adjuster Frame Nuts
    GM755845Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the 4 nuts that secure the seat pan to the power seat adjuster frame.

    Tighten:  Tighten the seat pan mounting nuts to 25 N.m (18 lb ft).

  2. Install the seat back. Refer to Seat Back Replacement - Front .
    3. Fig 2: Locating SIR Harness
    GM755831Courtesy of GENERAL MOTORS CORP.
  3. Install the SIR harness to the harness clips (2) on the seat adjuster.
  4. Install the SIR harness connector (1) to the seat adjuster bracket.
    5. Fig 3: Locating Seat Belt Buckle Nut
    GM755837Courtesy of GENERAL MOTORS CORP.
  5. Install the seat belt buckle to the seat adjuster.

    Tighten:  Tighten the seat belt buckle nut to 55 N.m (41 lb ft).

  6. Install the lumbar support cable to the seat adjuster. Refer to Lumbar Support Cable Replacement .
  7. Install the seat cushion trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  8. Install the front bucket seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals