LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Rest Replacement - Rear Seat and Midgate >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Rear Seat Rest
    GM1236762Courtesy of GENERAL MOTORS CORP.
  1. Position the rear seat rest onto the floor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 4 rear seat rest nuts onto the floor studs.

    Tighten:  Tighten the rear seat rest nuts to 10 N.m (88 lb in).

  3. Install the rear seat rest cover. Refer to Cover Replacement - Rear Seat Floor Trim Panel Stud (Envoy XUV) .
scientia non olet · About LEMON Manuals