LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Outer Riser Assembly Replacement - Rear No. 2 >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat from the vehicle. Refer toSeat Replacement - Rear No. 2 .
  2. Remove the seat latch rod. Refer to Seat Latch Rod Replacement - Rear No. 2 .
  3. Remove the seat riser latch assembly. Refer to Seat Riser Latch Assembly Replacement - Rear No. 2 .
  4. Remove the seat adjuster cross bar. Refer to Seat Adjuster Cross Bar Replacement - Rear No. 2 .
    5. Fig 1: Unhooking the J-strip
    GM824164Courtesy of GENERAL MOTORS CORP.
  5. Unhook the J-strip (1) from the bottom of the seat back cover.
  6. Remove the hog rings (2) from the seat back cover flaps.
  7. Pull the seat cover up to expose the seat back mounting bolts.
    8. Fig 2: Seat Recliner View
    GM824165Courtesy of GENERAL MOTORS CORP.
  8. Remove the two seat back mounting bolts (1) securing the outer riser assembly to the seat back frame.
scientia non olet · About LEMON Manuals