LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Outer Riser Assembly Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Recliner View
    GM824165Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the two seat back mounting bolts (1) securing the outer riser assembly to the seat back frame.

    Tighten:  Tighten the seat back mounting bolts to 25 N.m (18 lb ft).

  2. Pull the seat cover back down over the seat pad.
    3. Fig 2: Unhooking the J-strip
    GM824164Courtesy of GENERAL MOTORS CORP.
  3. Secure the seat back cover flaps to the pad with the hog rings (2).
  4. Install the J-strip (1) on the bottom of the seat back cover.
  5. Install the seat adjuster cross bar. Refer to Seat Adjuster Cross Bar Replacement - Rear No. 2 .
  6. Install the seat riser latch assembly. Refer to Seat Riser Latch Assembly Replacement - Rear No. 2 .
  7. Install the seat latch rod. Refer to Seat Latch Rod Replacement - Rear No. 2 .
  8. Install the seat in the vehicle. Refer toSeat Replacement - Rear No. 2 .
scientia non olet · About LEMON Manuals