LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Mid-Position Floor Latch Assembly Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat from the vehicle. Refer to Seat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
  2. Remove the trim panel from the seat cushion. Refer to Seat Cushion Trim Panel Replacement - Rear No.1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
  3. Remove the rear center seat belt buckle assembly from the floor latch assembly. Refer to Seat Belt Buckle Replacement - Center Rear (TrailBlazer, Envoy, Bravada) or Seat Belt Buckle Replacement - Center Rear (TrailBlazer EXT, Envoy XL, Envoy XUV) in Seat Belts.
    4. Fig 1: Removing/Installing Mid-Position Floor Latch Assembly
    GM828232Courtesy of GENERAL MOTORS CORP.
  4. Remove the cable (3) from the mid-position floor latch assembly (2).
  5. Remove the bolts (1) securing the mid-position floor latch assembly to the seat cushion frame.
  6. Remove the mid-position floor latch assembly.
scientia non olet · About LEMON Manuals