LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Mid-Position Floor Latch Assembly Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Mid-Position Floor Latch Assembly
    GM828232Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the mid-position floor latch assembly to the seat cushion frame with the bolts (1).

    Tighten:  Tighten the rear seat mid-position floor latch assembly bolts to 35 N.m (26 lb ft).

  2. Install the cable (3) to the mid-position floor latch assembly (2).
  3. Install the rear center seat belt buckle assembly to the floor latch assembly. Refer to Seat Belt Buckle Replacement - Center Rear (TrailBlazer, Envoy, Bravada) or Seat Belt Buckle Replacement - Center Rear (TrailBlazer EXT, Envoy XL, Envoy XUV) in Seat Belts.
  4. Install the trim panel to the seat cushion. Refer to Seat Cushion Trim Panel Replacement - Rear No.1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
  5. Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
scientia non olet · About LEMON Manuals