LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Lumbar Replacement - Front Seat >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the lumbar assembly onto the seat.
    2. Fig 1: Locating Lumbar Motor Mounting Screw
    GM753526Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the lumbar motor mounting screw.

    Tighten:  Tighten the lumbar motor mounting screw to 8 N.m (71 lb in).

  3. Attach the lumbar clips onto the top and bottom of the seat back frame.
  4. Connect the electrical connector to the lumbar motor.
  5. Install the seat back panel. Refer to Seat Back Panel Replacement - Front .
  6. Install the seat back pad and cover. Refer to Seat Back Cover and Pad Replacement - Front .
  7. Install the seat in the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals