LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (Seat System) >> Repair Instructions >> Head Restraint Retractor Assembly Replacement - Rear No. 1 >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Prevent Accidental Deployment of the Head Restraint Retractor Assembly in Cautions and Notices.
  1. Remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
    2. Fig 1: Identifying Head Restraint Retractor Assembly To Seat Back Frame Bolts
    GM753545Courtesy of GENERAL MOTORS CORP.
  2. Remove the 3 bolts that retain the head restraint retractor assembly to the seat back frame.
    3. Fig 2: Positioning Head Restraint Retractor Assembly Near Seat Back Frame
    GM753546Courtesy of GENERAL MOTORS CORP.
  3. Partially remove the head restraint retractor assembly from the frame.
    4. Fig 3: Removing/Installing Release Cable
    GM753547Courtesy of GENERAL MOTORS CORP.
  4. Remove the release cable by sliding the cable retainer over to the large access hole and removing the cable from the head restraint retractor assembly.
  5. Remove the retractor assembly from the seat back frame.
scientia non olet · About LEMON Manuals