Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Positioning Head Restraint Retractor Assembly Near Seat Back Frame

Courtesy of GENERAL MOTORS CORP.

Position the head restraint retractor assembly to the seat back.

Fig 2: Removing/Installing Release Cable

Courtesy of GENERAL MOTORS CORP.

Install the release cable through the head restraint retractor assembly access hole and sliding the cable retainer into position.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 3: Identifying Head Restraint Retractor Assembly To Seat Back Frame Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 3 bolts that retain the head restraint retractor assembly to the seat back frame.
Tighten: Tighten the head restraint retractor bolts to 10 N.m (88 lb in).
Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) or Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .