LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1393 (Door System, Mirror System & Window System) >> Repair Instructions >> Window Weatherstrip Run Channel Assembly Replacement - Rear (TrailBlazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Door With Trim Panel Removed
    GM800126Courtesy of GENERAL MOTORS CORP.
  1. Install the weatherstrip/run channel assembly to the door.
  2. Install the quarter glass into the window opening by pressing the window channel (4) rearward until the retaining clip is fully installed.
  3. Press the weatherstrip (1) into the window frame opening.
  4. Position the tabs on the weatherstrip into the slots on the door.
    5. NOTE: Refer toFastener Notice in Cautions and Notices.
  5. Install the weatherstrip/run channel retaining bolt.

    Tighten:  Tighten the bolt to 10 N.m (88 lb in).

  6. Install the window glass into the run channel, slide up to the closed position, tape the window to the door frame.
  7. Install the window regulator. Refer to Window Regulator Replacement - Rear Door (TrailBlazer, Envoy, Bravada) Window Regulator Replacement - Rear Door (TrailBlazer EXT, Envoy XL) .
  8. Install the water deflector. Refer to Water Deflector Replacement - Rear Door .
  9. Install the outer window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Outer .
  10. Install the inner window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Inner .
  11. Install the trim panel. Refer to Trim Panel Replacement - Side Rear Door .
scientia non olet · About LEMON Manuals