LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1393 (Door System, Mirror System & Window System) >> Repair Instructions >> Window Regulator Replacement - Front Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door .
  2. Remove the speaker. Refer to Speaker Replacement - Front Door in Entertainment.
  3. Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
  4. Loosen the regulator window carrier bolts.
  5. Raise and support the window.
    6. Fig 1: Regulator Assembly Bolts
    GM723037Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the electrical connector from the regulator motor.
  7. Loosen the upper 2 bolts that retain the regulator assembly to the door.
  8. Remove the remaining 3 bolts that retain the window regulator assembly and the motor to the door.
  9. Lift the regulator assembly upward in order to release the upper 2 bolts.
  10. Rotate the upper portion of the regulator assembly forward.
  11. Beginning with the lower portion, remove the regulator assembly through the door opening.
  12. Place the regulator assembly on a prepared surface.
  13. Remove the upper 2 bolts from the regulator assembly.
scientia non olet · About LEMON Manuals