LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1393 (Door System, Mirror System & Window System) >> Repair Instructions >> Switch Replacement - Door Lock and Side Window - Passenger >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Passenger Door Module Electrical Connectors
    GM791165Courtesy of GENERAL MOTORS CORP.
  1. Lift up on the front edge of the switch panel in order to release the front retaining clip.
  2. Lift up on the rear edge of the switch panel in order to release the 2 rear retaining clips.
  3. If equipped, disconnect the electrical connectors from the passenger door module (1).
  4. If replacing only the passenger door module, remove the module from the door trim panel.
  5. Disconnect the remaining electrical connectors from the switch panel.
  6. If replacing only the switch panel, retain the passenger door module for transfer.
  7. Remove the switch panel assembly from the vehicle.
scientia non olet · About LEMON Manuals