Balance Shaft Bearing and/or Bushing Removal

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 36995 Balance Shaft Bearing Remover/Installer

Use J 36995 to remove the balance shaft bearing.
Use J 36995 to remove the balance shaft bushing. It may take a considerable amount of force to loosen the bushing from the block bore.

Fig 1: Balance Shaft Bearing & Bushing Using J 36995
Courtesy of GENERAL MOTORS CORP.